Electronic boxes and shelves

Today you were able to get a lot done, and as it was more productive you were more optimistic about the project…

You went to Travis's at 0900 again and worked on the CAD models that you have been making the last couple days. After finishing all the parts for the heat sinks you worked on creating shelves and boxes for the embedded Linux controllers. 

You then ate lunch (leftover pizza) and played a little frisbee to get some fresh air and a break from the computer from about 1245 to 1330. You then finished the shelving and the boxes to epoxy the Raspberry Pi and BeagleBone in. You then made all the pieces so that they could either be 3D printed or cut out on the 3-axis router.

You then cut out part of the float to make sure you could easily fit the batteries into it. After that you programmed motor controllers to send down to Baxter so they can finish the thrusters. Then you headed home around 1845. 

Finally you tried on the tux that you Grandfather gave you and were happy to find that it fit really well.